*Note that I will not be held responsible to any damage to property or to the builder of this project.*
1 3′ long 3″ diameter ABS pipe
1 3″ to 5″ reducer bushing
1 2′ long 5″ diameter ABS pipe
1 5″ diameter connector one side smooth and other side threaded
5″ diameter threaded cap
Well, this is pretty self-explanatory. It’s best to do a dry-fit. Insert the 3′ pipe into the smaller end of the reducer bushing. Insert the 2′ long pipe into the other end of the bushing. Place the smooth part of the connector on the other end of the 2′ long pipe. Screw on the cap. Once all dry fit is done, try to take everything apart and cement it, following the same directions. Don’t forget to let glue dry before you launch a tennis ball!